Fitting the IMI-1000 (kit 800-316) to an Audi with the Concert or Symphony radio uses two guides: the installation guide for the fitting itself, and the IMI-1000 Setup Manual for setting it up afterwards. They replace the earlier installation guide, which should no longer be used.
Installation guide · for the fitting
IMI-1000 Installation Guide: Audi Concert / Symphony
Every step of the fitting: taking out the front control panel, the glovebox and the radio, each connection including the key-switch circuit board, fitting the module and the microphone and refitting. A switch-on test comes before anything is refitted.
Open the installation guide DownloadThe guide opens in a new tab. It can be read on a phone while working in the car.
After the fitting · setting up
IMI-1000 Setup Manual
This system uses the AUX method (Section B). The manual also covers connecting your phone, reverse camera settings and troubleshooting.
Setup guides page Open the manualStart here
How to use these guides
- 1
Check that the kit fits, and check the sound source
Make sure the car has the Concert or Symphony radio (see below), then press MEDIA (or SOURCE) and look for AUX or AMI among the sources.
Installation guide, page 4: Is this the right guide and kit?
- 2
Fit and connect the IMI-1000
Follow the installation guide from taking out the radio to refitting, with a switch-on test (section 05) before you refit anything.
Installation guide, sections 01 to 06
- 3
Set it up
Once the car is back together, the IMI-1000 Setup Manual takes over, with the AUX method, connecting your phone and echo cancellation.
Which cars
Will it fit my car?
This kit is for the Concert and Symphony radios without MMI: the radio has its own buttons and a large knob on the front. If your car has MMI controls by the gear lever, it needs a different kit.
| Audi model | Years and radio |
|---|---|
| A4 / S4 (B8) | 2008 to 2015, with the Concert or Symphony radio (no MMI) |
| A5 / S5 (8T) | 2008 to 2016, with the Concert or Symphony radio (no MMI) |
| Q5 (8R) | 2009 to 2016, with the Concert or Symphony radio (no MMI) |
| Other Audi models | Not covered: the A3, TT and older A4 radios are different. |
Common questions
Quick answers
If you need help, send photos first
We can only help when we can see what has been done: photographs of every connection you have made, your DIP switches, and the problem itself. Page 3 of the guide shows what to photograph.
Get support for this kitCheck for AUX or AMI before you start
The IMI-1000 sound plays through AUX or AMI, and this system uses the AUX method in the Setup Manual. The installation guide checks it with the car switched on, in section 05.
Installation guide, before you startDIP switch settings
With the external microphone supplied in the kit (the usual set-up): L H H H H H. With the car’s own microphone: H L H H H H. H is up and L is down; always follow the label on the module. If your car isn’t on the label, try each setting on the label in turn.
How the DIP switches workThe key-switch board ribbons
Do not twist the ribbons. The ribbon from the radio to the board fits only one way, and the ribbon from the board to the front panel connects straight. Hold each one by its blue stiffener.
Installation guide, section 03The settings passcode
If the IMI-1000 asks for the settings passcode during setup, it is 8818.
Installation guide, section 07Help with a fitted kit
Our support page shows the pages of this guide to check first, and sends us your photos with your request. Without the photos we cannot help.
IMI-1000

